PriceList for Sealed Angular Contact Ball Bearings - Self Aligning Ball Bearing factory – Chengfeng Bearing

Details

The difference between self-aligning bearings and other ordinary bearings

In a self-aligning bearing, the inner ring has two corrugations, the outer ring has a circular trajectory, and the center of curvature corresponds to the bearing axis. This allows the inner ring, ball and door frame to move around the center of the wire to automatically correct inconsistencies due to body jigs and fixtures or defects.

Why choose to use self-aligning bearings?

Mediation advises itself when it is difficult to align the post and housing or may bend during surgery. Similar to deep ball pressure, most self-propelled balls are universal.

Can they be replaced with standard bearing assemblies?
Depending on the series, most self-assembling bearings can be replaced with conventional bearing assemblies. (6200 and 6300 can be directly replaced with 1200 and 1300 series). However, if this is not possible, the self-aligning wave may be wider or may have an angled brush.

Advice on selection and installation

Bearing selection is based on load, speed and space constraints. Additionally, shaft inconsistencies and/or inconsistencies must be considered when determining bearing types.

Standard installation and handling procedures for cylindrical hollow bearings should be followed. For thin holes, special care should be taken to ensure the leads are pointed at the correct taper. Since it is important to adapt the cable to a specific application, it is important to check your application requirements with the supplier of your choice.